I also tried OmniOS, which started booting, but then likely froze with a black screen - I didn't see anything after a while on the console. AFAIR there were some warnings regarding the network interfaces (i226). I had a FreeBSD 13.1-RELEASE USB installer on hand, so tried that first, it booted nicely. I could easily get off the bottom cover, put in the DIMM and the mSATA SSD, put it together again and it booted nicely. There were some screws (for the internal SATA SSD) and some minimal documentation only inside - get in touch with their customer service for detailed photos and the AMI UEFI setup's manual, they will send these to you happily! The mini PC arrived very well-protected: in a double cardboard box with some additional foam spacer inside. Take a look at the comparison of 16 different operating systems.I already had a 256GB mSATA SSD, so I ordered the J6413 barebones version and a 8GB Crucial DIMM separately. If you are interested in a detailed comparison, please read pfSense vs OPNsense. TLSense routers achieve between 500Mbps - 1Gbps+ throughput with OpenVPN depending on the model.īoth are good, but here at TekLager, we are recommending OPNsense. More detailed information can be found in APU OpenVPN and Wireguard performance benchmark. If you have a choice between OpenVPN and Wigeguard, choose the latter. OpenWRT achieves about 140Mbit/s.ĪPU delivers more than 600Mbit/s with Wireguard VPN. On APU routers pfSense and OPNsense achieve about 100Mbit/s throughput. PfSense, OPNSense, and OpenWRT are working great with OpenVPN. See our Knowledge Base for more information. In these systems, VLAN configuration and PPPoE throughout will be limited. It's possible to get a full gigabit throughput on pfSense and OPNsense as well, but a few configuration tweaks are required. Both have great VLAN and PPPoE support as well. OpenWRT and IPFire achieve full gigabit routing on APU routers out of the box. I have an APU router and want to have a full gigabit internet speed. See more information about OpenWRT performance here. You should NOT use pfSense or OPNSense - they don't support 802.11ac and have sub-optimal 802.11n support. OpenWRT has the best Wireless support and achieves the highest wireless throughput. OpenWRT is excellent in many ways but less user-friendly for firewall configuration than OPNSense and pfSense. IPFire has a less mature user interface, so we only recommend it if you already know it. PfSense has been around for longer, so the community is bigger, and there's more documentation online. OPNsense has a nicer user interface and seems to implement new features faster than pfSense. Both of these operating systems are mature, full-featured, and have a lot of documentation online. Here are a few basic recommendations we make, depending on what you want to use your hardware for. It depends on what you want to do! Here, at TekLager, we run OpenWRT on our Access Points and OPNSense on our routers. Should I have pfSense or OPNSense, IPFire, or OpenWRT or maybe something completely different? This is one of the most frequently asked questions we get. Which Operating System should I have on my router?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |